Logic Applications - Shure ANI22 Manual

ANI22 Audio Network Interface
② Analog Input Sources
Analog sources, such as wireless microphones, connect to the analog line input
③ Analog Output Devices
Loudspeakers, amplifiers, or recording devices connect to the analog line output
④ Dante-enabled Equipment
Dante microphones, such as the Shure Microflex Advance ceiling and table arrays connect to the network switch and can be routed using Dante Controller
software.
⑤ Control CPU
A computer connected to the network accesses the web application to control the channel levels and processing.
⑥ Network Switch
The network switch provides Power over Ethernet (PoE) to the ANI22, while also supporting all other Dante-enabled audio equipment.
Summing
The Audio Network Interface provides channel summing to combine input signals and send them over a single output channel. This makes it possible to send
all channels to a device with a limited amount of Dante™ receiver channels or analog inputs. The relative channel levels are not affected; the mix is summed
in the device and sent over a single output channel.
Note: When summing is enabled, a limiter is activated to prevent signal overloading. The limiter never applies to the direct outputs, and only affects the summed
signal.
To enable, select one of the summing options in the toolbar at the top of the mixer in the channels tab.
1
2
3
4

Logic Applications

The block connecter inputs feature three logic signal connections. Logic signals are converted into Ethernet command strings and sent and received by any
device (such as an echo canceller or control system) that supports Ethernet command strings.
In this diagram, Shure MX392 Microflex
(switch) to mute other audio equipment. The microphones receive logic signals (LED) so that the microphone LED behavior reflects the state of the entire audio
system.
10/24
1
2
3 + 4
®
microphones are connected the audio network interface. The mute button on each microphone sends a logic signal
1
2
3
4
1
2
3
4
Shure Incorporated
1 + 2
3 + 4
1 +2
3
4
2017/10/10