Mitsubishi LE-30CTN Instruction Manual page 22

3. Screen system and method of change screen
2) To switch the screen by selecting an item number
Power-on
1:Tension setting
2:Manual Setting
3:Taper rate setting
10: Stop gain,
11: Gain 1,
• Set an item number using the value dial(16).
• If the selected item has only one screen, pressing the
setting item selection screen.
• If the selected item has two or more screens, use the
screen is displayed, pressing the
screen. If the lowermost screen is displayed, pressing the
setting item selection screen.
• If a screen has two or more items, pressing the
previous item. However, if the cursor is at the uppermost item, pressing the
the adjustment/setting item selection screen. If the cursor is at the lowermost item, pressing the
return the system to the adjustment/setting item selection screen.
20
Password
input screen
Adjustment/setting
item selection screen
20:
Full-scale tension
value, decimal
point setting
21:
Tension indication
filter time constant
setting
22: Manual zero point
adjusting
23: Manual span
adjusting
26: Zero tension
stop timer setting
detection
30:
Tension output
filter time constant
gain 2 setting
setting
When a password setting value is zero (default), the
password input screen is not displayed, and the
adjustment/setting item selection screen is displayed
wen the power is turned ON.
Select an item number using the setting dial(16), and
then press the
to the screen of the selected item.
31: Low excitation
setting
40: Proportional gain,
integral time
setting
41: Additional gain,
addition dead
zone setting
50: Contact input
setting for MI1,
MI2, MI3
or keys will return the system to the adjustment/
and
keys will return the system to the adjustment/setting item selection
key will return the system to the adjustment/
or key will move the under-cursor to the next or
3.2 Method of change screen
key (screen selection key) to move
51: Analog input
setting for AI1, AI2
52: Extension screen
setting
54: Pass word
setting
keys to switch the screen. If the uppermost
key will return the system to
key will