Toro Greensmaster Fixed Head Walk Behind Series Installation Instructions Manual page 9

7
Installing the Groomer
on the Right Side of the
Machine
Parts needed for this procedure:
1 Bearing Adapter
2 Spacer
1 Groomer-plate assembly
1 Adapter ring
2 Bolt (1/4 x 3-3/4 inches)
2 Star washer
2 Fastener retainer
1 Weight
Procedure
1. Remove the 4 bolts securing the reel-drive-belt
cover to the right, side plate and remove the
cover (Figure 17).
Figure 17
1. Reel-drive-belt cover
2. Loosen the idler pulley to relieve the belt tension
and remove the reel-drive belt from the pulleys
(Figure 18).
1. Reel drive belt
2. Idler pulley
3. Using a 1/2 inch drive ratchet and extension,
remove the drive pulley from the reel shaft
(Figure 18).
Note:
The drive pulley has right-hand threads.
4. Secure the reel from turning with a wood block.
5. Remove the 2 flat-head screws and nuts
securing the groomer arm cover to the bearing
housing and side plate
6. Remove the groomer arm cover
retain the flat-head screws and discard the
spacers under the cover.
7. If you are installing this kit on a Greensmaster
800 mower with a serial number prior to
230999999, a Greensmaster 1000 mower
with a serial number prior to 229999999, or
a Greensmaster 1600 mower with a serial
number prior to 260001401, remove the 2 bolts
and washers securing the right bedbar adjuster
frame to the side plate.
8. Remove the curved washer and the bolt (3/8 x
5/8 inch) from the adjustment-knob, mounting
block (Figure
g017184 9. Insert an adapter ring into the reel-bearing
housing (Figure
9
Figure 18
3. Drive pulley
4. Flat-head screw
(Figure 18).
(Figure
19).
19).
g017185
19);