Advertisement
1. Flat-head screw
2. Groomer arm cover
3. Bearing adapter
10.
Insert the 2 flat-head screws (3/8 x 2 inch)
through the groomer arm cover and the bearing
adapter and put a spacer over each screw
(Figure
19).
11.
Install the groomer arm cover, bearing adapter,
spacers, and groomer-plate assembly to
the reel-bearing housing, sliding the adapter
through the bronze bushing in the groomer plate
assembly and into the reel bearing housing
(Figure
19).
12.
Install the locknuts on the flat-head screws and
torque them to 31 to 37 N∙m (23 to 27 ft-lb).
13.
Secure the mounting block of the groomer
adjustment knob assembly to the right side plate
with the bolt (3/8 x 5/8 inch) and curved washer
removed previously
14.
If you are installing this kit on a Greensmaster
800 mower with a serial number prior to
230999999, a Greensmaster 1000 mower
with a serial number prior to 229999999, or
a Greensmaster 1600 mower with a serial
number prior to 260001401, install the right,
bedbar-adjuster frame to the side plate with the
bolts and washers you removed previously.
4. Spacer
5. Adjustment-knob, mounting block
6. Curved washer
(Figure
19).
Figure 19
7. Bolt
8. Adapter ring
9. Groomer-plate assembly
15.
Using a 1/2 inch drive ratchet and extension,
install the drive pulley (right-hand threads) to the
reel shaft
(Figure
1. Drive pulley
2. Idler pulley
16.
Secure the reel from turning with a wood block.
10
20).
Figure 20
3. Quick-up lever
4. Micro adjustment knob
g020847
g017188
Advertisement
