Advertisement
8.
Insert the 2 flat-head screws (3/8 x 2 inch)
through the bearing adapter and position the
spacers on the ends of the screws
Figure
8).
9.
Align the bearing adapter, spacers, and screws
with the bronze bushing and the slots in the
groomer housing.
10.
Slide the bearing adapter through the bronze
bushing and the screws through the slots in the
groomer housing assembly
8).
Important:
Ensure that the bearing adapter
is oriented as shown in
1. Bearing adapter
11.
Place the slot cover over the screws and up
against the lubricated O-ring
12.
Ensure that the flat edge of the slot cover is
oriented at the bottom.
13.
Insert the flat-head screws through the
reel-bearing housing and secure them with
locknuts.
14.
Torque the locknuts to 31 to 37 N∙m (23 to 27
ft-lb)
(Figure 6
and
Note:
To gain access to the locknuts you may
need to move or remove the bedbar.
15.
Mount the adjustment knob mounting block to
the left side plate with the bolt (3/8 x 5/8 inch)
and curved washer you removed previously
(Figure
6).
(Figure 6
(Figure 6
and
Figure
9.
Figure 9
(Figure
6).
Figure
8).
16.
If you are installing this kit on a Greensmaster
800 mower with a serial number prior to
and
230999999, a Greensmaster 1000 mower
with a serial number prior to 229999999, or
a Greensmaster 1600 mower with a serial
number prior to 260001401, install the left,
bedbar-adjuster frame to the side plate with the
bolts and washers that you removed previously
(Figure
Figure
4
Installing the Drive Gear
Parts needed for this procedure:
1
Shaft assembly
1
Drive gear
–
Synthetic grease
Procedure
1.
Remove the reel-bearing locknut from the reel
shaft
(Figure
Note:
g020854
right-handed threads.
1. Reel-bearing locknut
2.
Secure the reel from turning with a wood block.
3.
Thread the shaft assembly onto the reel-shaft
extension
6
4).
10).
The reel-bearing locknut has
Figure 10
(Figure
11).
g022029
Advertisement
