Advertisement
3.
Slide the groomer-reel shaft into the clamp on
the right side and swing it up to the drive shaft
on the left
(Figure
Important:
If installing a carbide-toothed
groomer, ensure that the teeth point in
the direction the groomer will rotate when
installed.
Figure 22
1. Bolt (1/4 x 1-1/4 inches)
2. Bolt (1/4 x 1-1/4 inches)—loosely installed in the clamp
3. Jam nut
Figure 23
1. Drive-stub shaft
2. Groomer assembly
3. Jam nut
4.
Secure the groomer reel with the clamps and
nuts as shown in
torquing the socket head screws to 9.6 to 10.5
N∙m (85 to 95 in-lb).
5.
Rotate both quick-up levers to raise the
grooming reel into the transport position
20).
22).
4. Shaft clamp
5. Bolt
Figure 22
and
Figure
6.
Correct any problems and check the assembly.
7.
Using a hand-pump grease gun, lubricate the 2
groomer-shaft bearings (1 on each end).
Note:
avoid permanently damaging the grease seals.
8.
Center the roller between the height-of-cut arms
and tighten the set screws and jam nuts.
g246532
g240752
23,
(Figure
12
Pump only 2 to 3 pumps maximum to
Advertisement
