Advertisement
1. Shaft assembly
2. Drive gear
4.
Secure the reel from turning with a wood block
and torque the shaft assembly to 54 to 81 N∙m
(40 to 60 ft-lb).
5.
Apply synthetic grease (supplied with the kit) to
the male spline of the shaft assembly
11).
6.
Slide the drive gear with the groove oriented
outward onto the shaft assembly
7.
Install the 40-tooth idler gear
5
Setting the Groomer for
Forward Rotation (Optional)
Parts needed for this procedure:
1
Forward Rotation Kit (obtain separately)
Procedure
The groomer comes designed to rotate in the opposite
direction of the reel. Optionally, you can set it to rotate
in the same direction as the reel by obtaining the
Forward Rotation Kit using the following procedure:
1.
Remove the 2 socket-head bolts and locknuts
from the cover
(Figure
Figure 11
3. Groove
4. 40-tooth idler gear
(Figure
(Figure
(Figure
11).
12).
g022024
1. Socket-head bolts—keep
one
2.
Keep one of the bolts and discard the rest of the
fasteners.
3.
Remove the center gear assembly, saving the
gear and discarding the bushing and bolt
13).
11).
1. Bushing—discard
2. Center gear—keep
4.
Install the socket-head bolt you removed from
the cover into the hole where the center gear
was installed
7
Figure 12
2. Locknuts—discard
Figure 13
3. Bolt—discard
(Figure
14).
g020880
(Figure
g020881
Advertisement
