Advertisement
17.
Torque the pulley to 54 to 81 N∙m (40 to 60 ft-lb).
18.
Install reel drive belt and check the belt tension
by pressing the belt at the mid span of the
pulleys with 1.5 to 2.5 kg (3 to 5 lb) of force.
The belt should deflect 6 mm (1/4 inch).
Reposition the idler pulley to adjust the belt
tension. Tighten the screws once you achieve
the proper tension.
19.
Install the reel-drive-belt cover to the side plate
as follows:
•
Greensmaster 800 mowers—install the reel
drive cover to the side plate with the 4 bolts
you removed previously.
•
Greensmaster 1000/1600 mowers—install
the cover using the upper and lower bolts
removed previously and the weight and new
fasteners as shown in
fastener retainers as required by your local
codes.
Figure 21
1. Bolt
2. Star washer
Figure
21. Use the
g020853
3. Weight
4. Fastener retainer
8
Installing the Grooming
Reel
Parts needed for this procedure:
4
Shaft clamp
4
Bolt (1/4 x 1-1/4 inches)
4
Jam nut
1
Groomer reel (obtain separately)
Procedure
1.
Obtain a groomer reel appropriate for your
needs and cutting unit; refer to the following
table for a list of groomer reels:
Model Number
04801
04802
04803
04280
04281
04283
04284
04286
04287
04268
04269
04270
04271
04276
2.
Loosely install the 2 halves of a groomer-shaft
clamp to the driven shaft on the right side of the
machine
(Figure 22
11
Groomer
18 inch groomer, twin tip
21 inch groomer, twin tip
26 inch groomer, twin tip
18 inch groomer, spring steel
18 inch groomer, carbide
21 inch groomer, spring steel
21 inch groomer, carbide
26 inch groomer, spring steel
26 inch groomer, carbide
18 inch soft grooming brush
18 inch stiff grooming brush
21 inch soft grooming brush
21 inch stiff grooming brush
26 inch stiff grooming brush
and
Figure
23).
Advertisement
