Toro Greensmaster Fixed Head Walk Behind Series Installation Instructions Manual page 3

5. Install the height-of-cut arms as follows:
•
Greensmaster 1600 mowers—obtain 2 new
height-of-cut arms from your authorized Toro
distributor and install them onto the roller
assembly and side plates with the fasteners
removed previously
•
Greensmaster 800 and 1000 mowers—rotate
the height-of-cut arms you removed
previously to the forward position and install
them onto the roller assembly and side
plates with the fasteners removed previously
(Figure 2).
Figure 2
1. Height-of-cut arm in the forward position
(Figure 2).
g017179
3
Installing the Groomer
Housing
Parts needed for this procedure:
1 Groomer-housing assembly
2 Flat-head screw (3/8 x 2 inches)
2 Locknut (3/8 inch)
1 Bearing adapter
2 Spacer
1 O-ring
-
Synthetic grease
1 Slot cover
1 Adapter ring
Procedure
1. Remove the 2 bolts and locknuts securing the
end cap to the left, reel-bearing housing and the
side plate.
2. Remove and retain the end cap and fasteners
for use if you ever remove the groomer
3).
1. End cap
2. Bedbar-adjuster frame
3
Figure 3
3. Spring tension screw
4. Bolts and washers
(Figure
g017288