Address Range Switches - IBM RT User's Setup Manual

Address Range Switches

The address switches are set for operation of one adapter in a
system. If you install more than one adapter, you must set the
address switches. Likewise, if you are adding adapters to a system
that already has one or more asynchronous adapters installed, you
must remove the installed adapters and set the address switches as
shown below.
Use an opened paper clip or a ball-point pen to set the address
switches.
Adapter
You can install either 4-port adapter in adapter slot 2,
In sta llin g :
4, 5, 7, or 8 in IBM 6150 and in slot 2, 3, 4, or 5 in IBM 6151,
whichever is available. See the system unit diagram for the correct
adapter slot.
Section 6. Communication and Network Adapter Options 6-35
Switch Bank 2
Adapter
AJZIF162