Address Range Switches - IBM RT PC Options Installation

Address Range Switches
The address switches are set for operation of one adapter in a system.
If
you install more than one adapter, you must set the address switches.
Likewise,
if
you are adding adapters to a system that already has one or
more asynchronous adapters installed, you must remove the installed
adapters and set the address switches as shown below.
Use an opened paper clip or a ball-point pen to set the address switches.
Switch Bank 2
Adapter
Adapter
t~~MM~
3
tM;M~M
,
2
i~iMA~M
4
mMi~U~
Installing: You can install either 4-port adapter in adapter slot 2, 4, 5, 7, or
8 in mM 6150 and in slot 2,3,4, or 5 in IBM 6151, whichever is available.
See the system unit diagram for the correct adapter slot.
6-32
Options Installation