Attaching The 87691Vx Tape Autoloader To The Rails - IBM 87691VX VXA320 User Manual

Attaching the 87691VX Tape Autoloader to the rails

To attach the autoloader to the rails, complete the following steps:
__ 1. From the front of the rack, place the autoloader onto the shelf that is created
Figure 10. Placing the autoloader on the rails
__ 2. Slide the autoloader all the way back until it makes contact with the small
__ 3. From the back of the rack, attach the autoloader to the rails by inserting an
Figure 11. Attaching the autoloader to the rails
Note: For information about connecting cables and attaching the 87691VX Tape
by the rails (see Figure 10).
flanges near the back of the rails. The front edge of each shelf piece slides
under the metal tabs at the bottom front edge of the autoloader.
M3 screw into each of the small flanges (see Figure 11). Tighten the screws,
using a #1 Phillips screwdriver.
Autoloader to a host system, see Chapter 3, "Installing and setting up the
87691VX Tape Autoloader," on page 15.
Insert Screw Here
Chapter 2. Mounting the 87691VX Tape Autoloader in a rack
13