Table of Contents
Advertisement
NO
YES
CRU list
This section lists the customer replaceable units (CRUs) that can be replaced.
Removal and replacement procedures
If you are instructed to return a device or component, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Replacing the autoloader tape drive
This section describes how to replace the autoloader tape drive.
Note: If your autoloader is installed in a rack, it is not necessary to remove the
Removing a tape drive
To remove the tape drive, complete the following steps:
__ 1. Make sure that the environment is free of conditions that could cause
__ 2. Turn off the autoloader and disconnect the power cord.
DANGER
__ 3. Locate the tape drive cover plate at the back of the autoloader.
Replace the 87691VX Tape Autoloader.
Cleaning the 87691VX Tape Autoloader corrected the problem.
Table 5.
CRU part number
39M3640
40K2556
01K6484
35l0145
6952300
36L8861
42C3911
autoloader from the rack to replace the tape drive. It is also not necessary to
disconnect the SCSI cable, terminator, or Ethernet cable from the back of the
autoloader if they do not interfere with your access to the tape drive.
electrostatic discharge (ESD). If possible, use an antistatic mat and a
grounded static protection wristband during installation. If a mat and
wristband are not available, touch a known grounded surface, such as a
metal computer chassis.
Electrical current from power, telephone, and communication cables is
hazardous. See "Safety" on page v for more information.
Description
Tape drive
87691VX Tape Autoloader
External SCSI cable
External SCSI terminator
US power cord
PDU power cord
Rack mounting rails
Chapter 6. Autoloader Maintenance
Tier
Tier 1
Tier 1
Tier 1
Tier 1
Tier 1
Tier 1
Tier 1
47
Advertisement
Table of Contents
