Table of Contents
Advertisement
Attaching the rails to the rack
To attach the rails to the rack, complete the following steps:
__ 1. Position the left-side set of rails in the rack so that the front flange is inside
Insert screws here
Figure 8. Attaching the left side rail to the front of the rack
__ 2. Insert two M5 screws (the black screws from the kit) through the front
__ 3. Adjust the reach of the rails as necessary to position the back flange of the
Figure 9. Attaching the left side rail to the back of the rack
__ 4. From the back of the rack, insert an M5 screw (the silver screws from the
the front screw holes in the rack (see Figure 8).
flange of the rail (see Figure 8). Attach a nut to each screw. If your rack has
square mounting holes or the holes are much larger than the screws that are
provided in the kit, use a washer with the nut. Finger-tighten the nut.
rail outside of the screw holes at the back of the rack (see Figure 9).
kit) through the back flange of the rail (see Figure 9). Attach a nut to the
screw. If your rack has square mounting holes or the holes are much larger
than the screws that are provided in the kit, use a washer with the nut.
Finger-tighten the nut.
Front Flange
Chapter 2. Mounting the 87691VX Tape Autoloader in a rack
Insert Screw Here
Back Flange
11
Advertisement
Table of Contents
