Fujitsu PRIMERGY RX600 S3 SAS Operating Manual page 64

Switching the server on and off
Switching the server OFF
The power on indicator lights up green (item 7 in Figure
Ê Shut down the operating system properly.
The server is switched off automatically and goes into standby mode. The
power-on indicator remains unlit.
I
If the server does not switch off immediately, hold the On/Off button down
for at least four seconds or send a corresponding control signal.
Other on/off options
In addition to the On/Off button, the server can be switched ON and OFF in the
following ways:
– Configured switch-on/switch-off time
The server is switched ON or OFF at a time specified in the ServerView
program.
– Ring indicator
The server is switched on by an internal or external modem.
– Wakeup on LAN (WOL)
The server is switched on by a command via the LAN (Magic Package).
– After a power failure
The server automatically reboots following a power failure (depending of the
settings in the BIOS).
– Power override function
The server can be switched off immediately by pressing and holding the
On/Off button (approx. 4 - 5 sec.).
V
CAUTION!
There is a risk that data may be lost.
– IPMI
The server is switched on from an IPMI console (via the COM1 serial
interface or the RJ45 LAN interface).
64 Operating manual
Startup and operation
12 on page 51).
RX600 S3 SAS