Fujitsu PRIMERGY RX600 S3 SAS Operating Manual page 38

Installing the server in the rack/...
DataCenter Rack
– Telescopic or sliding rails mounted directly on the side (except in the rear left
area where a support bracket is used).
– Enhanced cable management in the lateral rack area.
Mounting of the rails in the different racks is described in the following sections.
Installation of cable management is described in detail in the Technical Manual
for the respective racks.
The following applies to rack systems from other manufacturers:
3rd party rack
Certain general conditions must be met:
– Installation dimensions (see also figure
1 Front of rack
2 Rear of rack
A Rack depth (comparable with PRIMECENTER Rack 940/1000 mm)
B Rack width (comparable with PRIMECENTER Rack 700 mm)
C Inner width of 19" installation level
C1 Front 19" installation level
C2 Rear 19" installation level
D Cable routing area (cable area depth) and ventilation
E Space for front panel and ventilation
F Space for right and left support systems
P PRIMERGY rack installation depth
a1 Front left support upright
a2 Front right support upright
b1 Rear left support upright
b2 Rear right support upright
38
2 on page
Operating manual
Hardware installation
39):
RX600 S3 SAS