About This Manual; Aim Of The Manual - Epson OmniLink TM-T70-i Technical Reference Manual

About this Manual

Aim of the Manual

This manual aims to provide all the information necessary for the development, design, and
installment of POS systems, order entry systems, and other receipt issuing systems that use TM-T70-
i.
TM-T70-i provides different available functions depending on the product specification and TM-i
Firmware version.
Refer to an appropriate Technical Reference Guide described in the following table.
TM-T70-i product
*1
specifications
TM-T70-i
(with a Serial port)
TM-T70-i
(without a Serial port)
*1: You can check the rear of the printer for the availability of serial ports.
TM-T70-i (with a Serial port)
*2: For TM-T70-i (without Serial port), print a status sheet to confirm whether the version of TM-i
Firmware is 4.0 or later. Make sure that this product is ready to print (the paper is set and the power
is turned on), and hold down the push button at the rear of this product for at least 3 seconds before
releasing it.
(See "Confirming with a status sheet" on page
TM-i Firmware Ver.4.0 or later
<General Information>
Firmware
X.XX
ePOS-Device
X.XX
Model
TM-T70-i
Time
"Firmware" (TM-i Firmware Version) is printed under
<General Information>.
TM-i Firmware Version
Ver.4.0 or later
Ver.4.0 or later
Ver.3.x or earlier
9 pin connector (Male)
47.)
*2
Technical Reference Guide to be used
TM-T70-i (TM-i Firmware Ver.4.0 or later)
Technical Reference Guide (This document)
TM-T70-i (TM-i Firmware Ver.4.0 or later)
Technical Reference Guide (This document)
TM-T70-i Technical Reference Guide
TM-T70-i (without a Serial port)
15 pin connector (Female)
TM-i Firmware Ver.3.x or earlier
<General Information>
Software
X.XX
Model
TM-T70-i
Time
yyyy-mm-dd hh:mm:ss
"Software" (TM-i Firmware Version) is printed under
<General Information>.
(Blue)
7