Settings For Connected Devices - Epson OmniLink TM-T70-i Technical Reference Manual

Settings for Connected Devices

The Epson ePOS SDK, ePOS-Device XML, ePOS-Print XML, Server Direct Print, and Device Data
Notification systems identify controlled devices by the device ID. The device ID is registered in this
product. Set the device ID using EPSON TMNet WebConfig.
This section briefly explains the setup procedure.
1. Connect the controlled devices
Physically connect (or connect via network) this product to all devices to be controlled by the
product, and turn the power on.
For devices that can be controlled, see
2. Check the information of the controlled devices
Check the type and IP address of devices to be controlled via this product.
In addition, check the device ID to be set for the controlled devices with the system administrator.
3. Start EPSON TMNet WebConfig
Access the address bar of the Web browser on the PC for setting to start EPSON TMNet WebConfig.
When SSL is disabled: http://[This product's IP address]/webconfig
When SSL is enabled: https://[This product's IP address]/webconfig
For detail, see "Starting EPSON TMNet WebConfig" on page
4. Register the controlled devices
From [Printer], [Customer Display], [Key Input Device], or [Serial Communication Device] in the
[Configuration] menu, register and set up the controlled devices.
After setting, click [Apply] or [Add] at the bottom of the screen. Then the settings are written to the
product. If [Apply] or [Add] is not clicked, the settings are not applied.
For detail, see the following information.
• Printer:
• Customer Display:
• Key Input Device:
• Serial Communication Device:
"Software Specifications" on page
For setting this product and TM printer on the network device
IDs and performing test prints.
For setting whether to use the Customer Display and perform-
ing test display. The communication settings of this product
must be made to match the Customer Display's communication
settings. The device ID is set to fixed, "local_display".
For setting device IDs for barcode scanners and key input
devices, selecting control scripts, and performing operational
tests. (page 82)
For setting whether to use the Serial Communication Device,
configuring communication settings, and performing communi-
cation tests. Communication settings of this product should
match those of a serial communication device. The device ID is
set to fixed, "local_serial".
Chapter 2
110.
76.
(page 80)
(page 82)
Setup
2
(page 81)
53