Enabling Php - Epson OmniLink TM-T70-i Technical Reference Manual

Enabling PHP

To use PHP on this product, enable PHP using EPSON TMNet WebConfig.
The spooler cannot be used if PHP is enabled.
This section briefly explains the setup procedure.
1. Check the microSD card
Make sure that the microSD card is installed in the microSD card slot on this product.
2. Start EPSON TMNet WebConfig
Access the address bar of the Web browser on the PC for setting to start EPSON TMNet WebConfig.
When SSL is disabled: http://[This product's IP address]/webconfig/PHPSetting
When SSL is enabled: https://[This product's IP address]/webconfig/PHPSetting
3. Enable PHP
Select [Enable] from "PHP".
After setting, click [Apply] at the bottom of the screen. Then the settings are written to the product. If
[Apply] is not clicked, the settings are not applied.
50