Settings For Spooler - Epson OmniLink TM-T70-i Technical Reference Manual

Settings for Spooler

To use the spooler with this product, you need to enable the spooler using EPSON TMNet
WebConfig.
This section gives an overview of the setup procedure.
1. Connect this product to the network
Connect this product to the network and turn on the power.
2. Start EPSON TMNet WebConfig
On the setup computer, enter the following into the address bar of your Web browser to start EPSON
TMNet WebConfig.
When SSL is disabled: http://[This product's IP address]/webconfig
When SSL is enabled: https://[This product's IP address]/webconfig
For details, see "Starting EPSON TMNet WebConfig" on page
3. Set the Spooler
Make spooler operation settings from [Settings] on the [Web Service Settings] menu.
Select [Enable] from [Spooler].
Set the number of retry times and the retry interval when the printer is not ready to print in [Retry
Settings].
After making settings, click [Apply] at the bottom of the screen. The settings are saved to this
product. Settings are not enabled unless you click [Apply].
For details, see "Web Service Settings - Spooler - Settings" on page
60
 PHP cannot be used if the spooler is enabled.
 You can use with TM-i firmware Ver.4.1 or later for this product.
76.
83.