Enabling Php; Setting For Server Direct Print - Epson TM-T83II Technical Reference Manual

Enabling PHP

To use PHP on this product, enable PHP using EPSON TMNet WebConfig.
This section briefly explains the setup procedure.
1. Check the microSD card
Make sure that the microSD card is installed in the microSD card slot on this product.
2. Start EPSON TMNet WebConfig
Access the address bar of the Web browser on the PC for setting to start EPSON TMNet WebConfig.
http://TM-i's IP address/webconfig/PHPSetting
3. Enable PHP
Select [Enable] from "PHP".
After setting, click [Apply] at the bottom of the screen. Then the settings are written to the product. If
[Apply] is not clicked, the settings are not applied.

Setting for Server Direct Print

Set up Server Direct Print using EPSON TMNet WebConfig.
This section briefly explains the setup procedure.
1. Connect this product to a network
Connect this product to a network and turn on the product.
2. Start EPSON TMNet WebConfig
Access the address bar of the Web browser on the PC for setting to start EPSON TMNet WebConfig.
http://TM-i's IP address/webconfig/
For detail, see "Starting EPSON TMNet WebConfig" on page
3. Set up Server Direct Print
Select the [Web Service Settings] menu and then [Direct Print], and set Server Direct Print settings.
After setting, click [Apply] at the bottom of the screen. Then the settings are written to the product. If
[Apply] is not clicked, the settings are not applied.
For detail, see "Web Service Settings - Server Access - Direct Print" on page
56
72.
87.