Avaya Ethernet Routing Switch 8300 Series Quick Start Manual page 38

Configuration
Configuring the system using the setup utility
Use the setup utility for the initial configuration of the switch. The setup utility uses a series of
questions to guide you through the configuration process.
Important:
Answer each question, or accept the default by pressing Enter. Each question includes the
default value in brackets and the acceptable parameter options in parenthesis.
The setup utility configures the Ethernet Routing Switch 8300 with a management IP address
and basic functionality such as enabling FTP, TELNET, and TFTP.
Procedure steps
1. Power up the system.
2. Connect through the console and logon as a default user (rwa) and Password (rwa)
3. To continue, type y
4. Follow the setup utility prompts. See
5. Restart the switch.
To customize your switch configuration, see Avaya Ethernet Routing Switch 8300 Release
Notes — Software Release 4.1, NN46200-401 for a list of Avaya Ethernet Routing Switch 8300
documents and information about the latest features.
Job aid: Setup utility prompt descriptions
The following table describes the setup utility prompts.
38 Quick Start
by using the following command:
install
Important:
You must be connected to the master CPU to use the install script.
After you run the setup utility, remember to reboot the switch.
A Welcome to ERS 8000 setup utility message appears stating that you are starting
initial configuration of the switch.The data is stored in /flash/boot.cfg and the runtime
configuration flash/config.config files.
page 38.
Job aid: Setup utility prompt descriptions on
May 2011