Avaya Ethernet Routing Switch 8300 Series Quick Start Manual page 39

Table 3: Setup utility prompt descriptions
Please provide primary config-
file path [/flash/config.cfg]:
Please provide primary image-
file path [flash/p80a.img]:
Please provide primary
license-file path [/flash/
license.dat]:
Please add system prompt
[Passport-8300]
Please select CPU Master slot
(5/6) [5]:
Master CPU mgmt port:
autonegotiation [n] (y/n)?
speed (10/100) [10]:
Do you want to enable FTP [n]
(y/n)?
Do you want to enable
RLOGIN [n] (y/n)?
Do you want to enable
TELNET [n] (y/n)?
Do you want to enable TFTP
[n] (y/n)?
Do you want to enable WEB
server service [n] (y/n)?
IP Address for mgmt port in
first CPU Slot [0.0.0.0/0.0.0.0]:
Quick Start
Prompt
Press Enter to accept the default (/flash/config.cfg), or
enter a different file name for the primary configuration file.
To store the configuration file on the PCMCIA card, use /
pcmcia/config.cfg. Specifying the path to the file is
optional.
Press Enter to accept the default (p80a.img), or enter a
different file name for the primary image file. Specifying the
path to the file is optional. If the runtime image resides on
a PCMCIA card, you must specify the /pcmcia/filename.
Press Enter to accept the default (/flash/license.dat), or
enter a different file name for the primary license-file.
Specifying the path to the file is optional. If the license file
resides on a PCMCIA card, you must specify the /pcmcia/
filename.
Press Enter to accept the default (Passport-8300), or enter
a different string of up to 20 characters.
Press Enter to accept the default (5), or specify 6 for the
master CPU slot.
Enter
want the master CPU management port to use
autonegotiation.
Press Enter to accept the default (10 Mbps), or specify 100
Mbps.
Enter
the default (
Enter
Accept the default (
Rlogin.
Enter
if you do not want to enable Telnet.
Enter
if you do not want to enable TFTP.
Enter
the default (
service.
Enter the IP address of the management port in the first
CPU slot.
Configuring the system using the setup utility
Action
n to accept the default, or enter
y if you want to enable FTP for remote users. Accept
n ), if you do not want to enable FTP.
y if you want to enable Rlogin for remote users.
n ), if you do not want to enable
y if you want to enable Telnet. Accept the default (
y
if you want to enable TFTP. Accept the default (
y if you want to enable WEB server service. Accept
n ), if you do not want to enable WEB server
y to indicate that you
n ),
n
),
May 2011 39