Eap Radius Vlan Is Not Being Applied - Avaya 3500 Series Troubleshooting Manual

Troubleshooting authentication
1. Use the eapol multihost eap-packet-mode unicast command to set the
2. Ensure that there are no errors after execution.
Setting EAPOL request packet for a port
Change the EAPOL request packet from multicast to unicast for a specific port.
1. Enter the Interface Configuration mode.
2. Use the eapol multihost eap-packet-mode unicast command to set the

EAP RADIUS VLAN is not being applied

Ensure that the RADIUS VLAN is applied correctly to support EAP.
Work flow EAP RADIUS VLAN is not being applied
The following work flow assists you to determine the cause and solution of the RADIUS VLAN
not being applied.
96 Troubleshooting 5.1
EAPOL request packet to unicast.
EAPOL request packet to unicast for the interface.
Comments? infodev@avaya.com
February 2013