Avaya 3500 Series Troubleshooting Manual page 102

Troubleshooting authentication
Figure 44: Configure the switch
Showing EAPOL port
Display the EAPOL port information
1. Use the show eapol port <port> command to display the port information.
2. Ensure that EAP is enabled globally, and that the port EAP status is set to auto.
Setting global EAP enabled and port at eap-auto
Make corrections to ensure that EAP is enabled globally, and that the port EAP status is set
to auto.
1. Use the eapol enable command to enable EAP globally.
2. Use the eapol status auto command to change port status to auto.
102 Troubleshooting 5.1
Comments? infodev@avaya.com
February 2013