Avaya 3500 Series Troubleshooting Manual page 80

Configuring SLA Monitor
Procedure
1. Log on to Application Configuration mode in ACLI.
2. To configure the agent IP address, enter the following command:
3. To configure the agent IP address to its default value , enter the following command:
4. To configure the UDP port, enter the following command:
5. To configure the agent UDP port to its default value , enter the following command:
6. To enable the agent, enter the following command:
7. To disable the agent, enter the following command:
8. To configure the agent-to-agent communication port , enter the following command:
9. To configure the agent-to-agent communication port to its default value, enter the
10. To enable the SLA Monitor agent CLI support, enter the following command:
11. To disable the SLA Monitor agent CLI support, enter the following command:
12. To configure the agent automatic CLI session timeout value, enter the following
13. To enable the agent automatic CLI session timeout, enter the following command:
80 Troubleshooting 5.1
slamon agent ip address {A.B.C.D}
default slamon agent ip address
slamon agent port <0–65535>
default slamon agent port
slamon oper-mode enable
no slamon oper-mode [enable]
OR
default slamon oper-mode
slamon agent—comm—port <0–65535>
following command:
default slamon agent—comm—port
slamon cli enable
Note:
The CLI commands affect only the SLA Monitor CLI and not the standard platform
CLI.
no slamon cli [enable]
OR
default slamon cli
command:
[default] slamon cli–timeout <60–600>
slamon cli–timeout—mode enable
Comments? infodev@avaya.com
February 2013