Avaya 3500 Series Troubleshooting Manual page 81

14. To disable the agent automatic CLI session timeout, enter the following command:
15. To configure the agent server IP address, enter the following command:
16. To configure the agent server IP address to its default value, enter the following
17. To configure the server TCP registration port, enter the following command:
18. To configure the server TCP registration port to its default value, enter the following
Example
tbd
Next steps
If you have configured SLA Monitor yet the agent is not functioning as expected, determine
task status using the engineering menu.
If the agent is not in the expected state, reset the system to start the agent.
If the agent task functions as expected, perform typical troubleshooting steps to verify agent
accessibility:
• Verify IP address assignment and port use.
• Verify that the SLA Monitor agent is enabled.
• Ping the server IP address.
• Verify the server configuration.
Variable definitions
The following table describes the parameters for the slamon command.
agent-comm-port <0–65535>
Troubleshooting 5.1
OR
default slamon cli–timeout—mode
no slamon cli–timeout—mode [enable]
slamon server ip address {A.B.C.C} [{A.B.C.D}]
command:
default slamon server ip address
slamon server port <0–65535>
command:
default slamon server port
Variable
Configuring the SLA Monitor agent using ACLI
Value
Configures the port used for RTP and NTR
testing in agent-to-agent communication.
The default port is 50012. If you configure
February 2013 81