Avaya 3500 Series Troubleshooting Manual page 106

Troubleshooting authentication
Setting global EAP enabled and port at eap-auto
Make corrections to ensure that EAP is enabled globally, and that the port EAP status is set
to auto.
1. Use the eapol enable command to enable EAP globally.
2. Use the eapol status auto command to change port status to auto.
Displaying EAPOL multihost
Review the EAPOL multihost information.
1. Enter the show eapol port multihost command to display the information.
2. Note the following:
Enabling RADIUS to authenticate non-EAPOL clients
Make the required changes to the password format on the RADIUS server.
Apply changes to the RADIUS server using vendor documentation.
Formatting non-EAPOL RADIUS password attribute
Make the required changes to the password format on the RADIUS server.
RADIUS server is to have the format changed to IpAddr.MACAddr.PortNumber.
Displaying EAPOL multihost interface
Review the EAPOL multihost information.
1. Enter the show eapol multihost interface <port#> command to display
2. Verify the following:
106 Troubleshooting 5.1
• Use RADIUS To Authenticate NonEAPOL Clients is enabled
• Non-EAPOL RADIUS Password Attribute Format:
IpAddr.MACAddr.PortNumber
the information.
Use RADIUS To Authenticate Non EAP MACs is enabled
Comments? infodev@avaya.com
February 2013