Safety Warnings - Juniper SRX5400 Getting Started Manual

5. When you have finished configuring the services gateway, exit configuration mode.
[edit]
admin@# exit
admin@>

Safety Warnings

WARNING:
is a summary of safety warnings. For a complete list of warnings for the services gateway,
including translations, see the SRX5400 Services Gateway hardware documentation at
www.juniper.net/documentation/.
WARNING:
to intrabuilding or unexposed wiring or cabling only. The intrabuilding port(s) of the
services gateway MUST NOT be metallically connected to interfaces that connect to the
outside plant (OSP) or its wiring. These interfaces are designed for use as intrabuilding
interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE, Issue 4) and
require isolation from the exposed OSP cabling. The addition of primary protectors is not
sufficient protection to connect these interfaces metallically to OSP wiring.
CAUTION:
ESD strap to an ESD point, and place the other end of the strap around your bare wrist.
Failure to use an ESD strap could result in damage to the services gateway.
CAUTION:
the services gateway.
Only trained and qualified personnel should install or replace the services gateway.
Perform only the procedures described in this guide or the SRX5400 Services Gateway Hardware Guide.
Other services should be performed by authorized service personnel only.
See installation instructions before you connect the services gateway. This
The intrabuilding port(s) of the services gateway is suitable for connection
Before you remove or install components of a services gateway, attach an
An external surge protective device (SPD) should be used at the AC input of
29