Group T, Auto-Tuning; T1 Im Motor Auto-Tuning - LiteOn EVO600021S0D2E20F User Manual

1 ∶ Time of Run
Keeps track of time when the output voltage is active.

o4-06 U2 Reset Setting
Resets the data for U2-□□ (Fault Information) as this data will not be reset by A1-03 (Reset).
No.
o4-06
0 : No Action
The data for the U2-□□ (Fault Information) monitor will not be reset.
1 : Enabled
Resets the data for the U2-□□ (Fault Information) monitor. Set this value to 1 and press ENTER
will clear all the fault information to 0.

o4- 07 to o4-08

6.9 Group t, Auto-Tuning

t1 parameters set the data for IM motor Auto-Tuning
Note: When running variable speed motors or vector motors, the voltage or frequency may
be lower than general-purpose motors. Therefore set the motor data according to the motor
nameplate and perform Auto-Tuning. After that, change the maximum output frequency in
d1-02.

t1-01 Auto-Tuning Method Selection
Selects the method of Auto-Tuning..
No.
t1-01 Auto-Tuning Method Selection
0 : Rotational Auto-Tuning
1 : Stationary Auto-Tuning 1

t1-02 Motor Output Power
Name
U2 Reset Setting
Retain

t1 IM Motor Auto-Tuning

Name
Setting Range
0,1
Setting Range
0,1,2
145
Default
0
Default
0