Group E, Multi-Function Terminals - LiteOn EVO600021S0D2E20F User Manual

□ Motor No-Load Current Setting
Sets the motor no-load current when running at no-load voltage and rated frequency. This
information is not written on the motor nameplate. Contact the motor manufacturer for the
information.
□ Number of Motor Poles Setting
d2-03 is only enabled in Closed-Loop V/F Control and Closed-Loop Vector Control. Enter the
number of motor poles written on the motor nameplate.
□ Motor Line-To-Line Resistance Setting
d2-04 will be set automatically during Auto-Tuning. However if Auto-Tuning cannot be
performed, contact the motor manufacturer for the test report. Use the line-to-line resistance
listed in the rest report to calculate the line-to-line resistance by the following formula.
· E-type insulation: the resistance value (Ω) listed on the test report at 75°C × 0.92
· B-type insulation: the resistance value (Ω) listed on the test report at 75°C × 0.92
· F-type insulation: the resistance value (Ω) listed on the test report at 115°C × 0.87
□ Motor Leakage Inductance Setting
d2-05 will be set automatically during Auto-Tuning.
□ Motor Rotor Resistance and Mutual Inductance Setting

6.6 Group E, Multi-Function Terminals

E1- 00 to E1- 05

Assigns functions to multi-function terminals S1 to S6. Set this parameter according to Table
6.18.
No.
E1-00 Terminal S1 Function Selection
E1-01 Terminal S2 Function Selection
E1-02 Terminal S3 Function Selection
E1-03 Terminal S4 Function Selection
E1-04 Terminal S5 Function Selection
E1-05 Terminal S6 Function Selection
E1 Multi-Function Digital Inputs
Terminal S1 to S6 Function Selection
Name Setting Range
0 to 73 0 : 2-Wire Sequence Control (Forward/Stop)
0 to 73 1: 2-Wire Sequence Control (Forward/Stop)
0 to 73
0 to 73
0 to 73
0 to 73 19: Baseblock Command (Normal Open.)
Table 6.18
95
Default
23 : External Fault
39: Fault Reset
9: Jog Frequency