Slave Response - LiteOn EVO600021S0D2E20F User Manual

11.8.2 Slave Response

In the following situations, the slave will ignore the command message sent from the master
and not respond to it.
When a communications error (overrun, framing, parity, or CRC) is detected in the

command message.
The slave address in the command message do not match the slave address in the drive

(Set the slave address for the drive using E6-06 in advance).
The gap between two blocks of a message is greater than 24 bits.

The command message length is incorrect.

Note: When the slave address in the command message is 00H, all slaves perform the write function, but do not
send any response message to the master.
189