Installation Tip - DJG Deluxe High Back 65 Instructions Manual

Installation Tip:

Loosely attach the
tether hook before
attaching the UAS
belt. Consult vehicle
owner's manual for
specific location.
2. Connect UAS to Vehicle
UAS Anchor Bar
Fasten one UAS hook to the
UAS anchor bar in the vehicle
seat bight. Repeat for other
side of child restraint.
3. Tighten UAS Belt
Place knee in the child
restraint. Push down firmly
while pulling up on the free
end of the UAS belt to tighten.
It may be easier to tighten
the belt through the belt path
opening as shown.
4.
Tighten the Tether Strap
With knee still in child restraint,
push down on the child
restraint again and pull on
free end of the tether strap to
tighten.
41
4358-6862A Deluxe High Back 65 ENG.indd 43-44 4358-6862A Deluxe High Back 65 ENG.indd 43-44
5. Check UAS Belt Tightness
Grasp the child restraint
at the belt path with one
hand. Push and pull the child
restraint from side to side,
forward and back. The child
restraint should not move
more than 2.5 cm (1 in)
and the UAS belt should not
loosen.
NOTE: If it moves more than 2.5 cm (1 in.) or if the UAS belt
loosens, try reinstalling the child restraint or try another seating
location.
6.
Secure Child in Child
Restraint
To Remove UAS Belt From
Vehicle Anchor Bar
Remove child from child
restraint.
Press down firmly on UAS
adjuster on side of child
restraint and press the UAS
adjuster release button to
release the tension in the belt.
1
(1) Unhook the UAS hooks
2
from vehicle anchor bar by
squeezing the spring lever,
push UAS hook into the
vehicle seat bight and twist
hook off the anchor bar. (2) Pull UAS hooks away from the
UAS anchor bars.
42
6/15/18 7:49 PM 6/15/18 7:49 PM