Epson Stylus PHOTO 950 Service Manual page 121

EPSON Stylus PHOTO 950
4.2.11.2 CR Motor Removal
1. Remove the Board Plate. (Refer to Steps 1 to 3 in Section 4.2.2.1.)
2. Disconnect the connector (CN5: red 2-pin) from the Main Board Assembly.
3. Remove the Timing Belt from the Pinion Gear on the CR Motor.
(Refer to Steps 8 in Section 4.2.6.)
4. Remove the two screws 11) C.P 3x6 that are securing the CR Motor, and then
remove the CR Motor.
1
11) C.P 3x6
Figure 4-60. CR Motor Removal
When installing the CR motor, the screws should be installed in the
C A U T I O N C A U T I O N C A U T I O N
order shown in Figure 4-60.
DISASSEMBLY AND ASSEMBLY
CR Motor
2
Disassembly
4.2.11.3 Pump Motor Removal
1. Remove the Board Plate. (Refer to Steps 1 to 3 in Section 4.2.2.1.)
2. Disconnect the connector (CN7: black 4-pin) from the Main Board Assembly.
3. Disengage the pump motor harness from the two hooks.
4. Remove the two screws 6) C.B.S 3x6 that are securing the Pump Motor.
6) C.B.S 3x6
Figure 4-61. Screws Securing the Pump Motor
5. Lower the pump motor, pull out the pinion gear and then remove the pump motor.
When installing the pump motor, the harness should be routed to
C A U T I O N C A U T I O N C A U T I O N
the right side.
Revision A
Pump Motor
Hooks
121