Setting The Blowing Of The Piping Strips - DURKOPP ADLER 745-35-10 S Service Instructions Manual

5.5 Setting the blowing of the piping strips

Fig. 78: Blowing the piping strips
(1) - Piping strip
(2) - Blast pipe pocket bag
(3) - Blast pipe piping strips
(4) - Clamping screw
(5) - Throttle valve flap clamp
The optional kit 0755 590804 for blowing is available for clamp K35
(method A). Furthermore, blast pipes are integrated in the folding plates
and the flap clamps. The blowing of the piping strip/pocket bag may be
necessary in case of thin fabrics and/or high piping projection.
Proper setting
The air stream escaping from blast pipes (2) and (3) must be adjusted in
such a way that the piping strip (1) is sufficiently blown on the pick-up fold-
er (8) and safely guided into the guide plates.
To set the blowing of the piping strips:
1. In the menu Program parameters > Program loading process
2. In the menu Program parameters > Program loading process
3. Position piping and pocket bag.
94
①
②
③
④
⑤
> Pedal mode press the
> Blowing mode set mode 2 ( p. 230).
(6) - Line blow-out (folding plate and flap clamp)
(7) - Throttle valve folding plate
(8) - Pick-up folder
button ( p. 233).
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
Transport clamps
⑧
⑦
⑥