DURKOPP ADLER 745-35-10 S Service Instructions Manual page 146

Fig. 126: Setting the guide plates at the folder (2)
(3) - Leaf springs
(4) - Screws
(5) - Screws
4. Align the guide plates (2)
5. Loosen the screws (4).
6. Loosen the threaded pin (7).
7. Adjust the guide plates (2) in longitudinal direction.
8. Adjust the threaded pins (6).
9. Tighten the screws (4).
10. Tighten the threaded pin (7).
Setting the spring pressure
To set the spring pressure:
1. Loosen the screws (5).
2. Adjust the pressure by aligning the leaf springs (3).
3. Tighten the screws (5).
144
⑤
③
④
The lower edges of the guide plates should be approx. 1 to 2 mm above
the fabric sliding plates.
⑥ ⑦ ⑥
(6) - Threaded pins
(7) - Threaded pin
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
Folder
④