Setting The Height Of The Stacker Tongs - DURKOPP ADLER 745-35-10 S Service Instructions Manual

2. Screw in or loosen the piston rod of the cylinder (1).
3. Tighten the counternut (2).

14.1.2 Setting the height of the stacker tongs

Fig. 135: Setting the height of the stacker tongs
(1) - Clamping lever
(2) - Axle
Proper setting
The closed stacker tongs (3) should be level with the plate (4) in the tabletop.
To set the height of the stacker tongs:
1. Loosen the clamping lever (1).
2. Manually push the stacker tongs (3) forward until the tongs close.
3. Tighten the clamping lever (1).
4. Loosen the clamping lever (1) so that you can slide the stacker tongs
156
①
②
in both directions on the axle (2) as well.
③
(3) - Stacker tongs
(4) - Plate
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
Stacker
④