Machine Head; Gages; Slot In The Arm Shaft Crank - DURKOPP ADLER 745-35-10 S Service Instructions Manual

Machine head

3

3.1 Gages

The gages listed below allow you to precisely set and check the sewing
unit.
The locking peg is included with the sewing unit as a standard tool in the
accessory pack. It can be used to peg the machine head into place in the
loop stroke position.
Gages
Setting gage
Locking peg
Gage
Measuring bridge
Measuring pin
Setting peg
Gage

3.2 Slot in the arm shaft crank

Fig. 1: Slot in the arm shaft crank
(1) - Slot
(2) - Arm shaft crank
The arm shaft crank (2) is fitted with a slot (1) (5 mm).
The machine head can be pegged into place in the hole (3) using the lock-
ing peg. When pegged in this position, the machine head is in the loop
stroke position.
Service Instructions 745-35-10 S/745-35-10 A - 02.0 - 04/2017
Machine head
①
Part number Use
0211 000700 Loop stroke position
0244 001001 Hook shaft height
0212 004942 Needle holder height
0216 001070 Needle holder height
0244 001014 Hook side clearance
0246 002591 Crank pin to arm shaft
② ③
(3) - Hole
15