Table of Contents
Advertisement
Chapter 2
Installing the Model 8000 Remote Access Concentrator
Installing the Model 8000 Remote Access Concentrator
2-10
Connecting Twisted Pair Ethernet (10BASE-T) Cable
To connect twisted pair (10BASE-T) Ethernet cable to the RAC
2-6):
(Figure
1.
Insert the connector located on the twisted pair Ethernet
cable into the 10BASE-T connector on the rear panel of the
RAC.
When the connector clicks into place, the connection is secure.
2.
Verify that the Link indicator is green.
The green Link indicator LED next to the 10BASE-T connector
goes on when power is applied and an active 10BASE-T
network segment is plugged in.
Figure 2-6. Connecting Twisted Pair Ethernet Cable
RA0009A
Advertisement
Table of Contents
