Table 4-5. Setup Mode Error Led States - Bay Networks 8000 RAC Installing Manual

Chapter 4 Troubleshooting Procedures
Activity T3: At the
Monitor Prompt
Activity TE2:
Hardware Failure
Installing the Model 8000 Remote Access Concentrator
4-8
When the STAT and ATTN LEDs are on, the ROM monitor prompt is
displayed on the console terminal. Enter the boot command at the prompt.
If you do not enter a file name with the command, you are prompted to
do so.
Setup Mode Error States
Table 4-5 describes the LEDs that are used to indicate errors at different
stages of the system startup process. If the RAC fails while testing the
hardware (state T2), the error condition is hardware failure TE2. A
description of each error condition follows

Table 4-5. Setup Mode Error LED States

Activity
TE2: Hardware Failure
TE7: Booted Wrong Image
Key:
On continuously
Off
Flashing regularly (about 1Hz)
The ROM diagnostics detected a RAC hardware problem requiring
service. Call the Technical Solutions Center.
Table 4-5.
STAT ATTN
Green Amber
TRAF
Green