Manage Onboard Raid System; Example For A Raid1 System During The Boot Phase Of The System - Siemens SIMATIC IPC1047 Operating Instructions Manual

Hide thumbs Also See for SIMATIC IPC1047:
Table of Contents

Advertisement

Device maintenance and repair

7.3 Manage onboard RAID system

Note
Use of the filter pad
We advise against using filter pads that have already been used. If you do want to refit a
filter pad you have removed, however, take account of the direction in which the fan draws
air into the device. Make absolutely certain that you do not fit the outer side of the filter pad
on the inside. Generally, the outer side is clearly dirty after it has been in use for some time.
7.3
Manage onboard RAID system
The RAID system of the manufacturer can also be used via the motherboard. The BIOS
setup is used to set up this system. Additional information is available in the sections
"RAID systems (Page 42)" and "Replacing a defective hard disk drive in the RAID system
(Page 60)".
Note
The key combination <CTRL+I> is only effective in "Legacy" mode. If the "Boot Type"
parameter is set to "UEFI Boot Type in the "Boot" menu in the BIOS setup, the RAID
hardware is configured by using the "Device Management" button in the BIOS selection
menu.
7.3.1

Example for a RAID1 system during the boot phase of the system

76
Operating Instructions, 09/2018, A5E45118479-AA
SIMATIC IPC1047

Advertisement

Table of Contents
loading

Table of Contents