Drives; Overview - Siemens SIMATIC IPC1047 Operating Instructions Manual

Expanding and assigning parameters to the device

6.4 Drives

6.4 Drives
6.4.1

Overview

You can mount the following drives and storage media in the device:
● Hard disk drive
● Solid State Drive
Note
Vibratory loads
During operation, the HDDs must not be exposed to vibratory loads and may only be
exposed to limited shock loads (see Technical specifications).
Tolerances for tightening torques
Unless otherwise specified, the tolerances of the torques specified in these operating
instructions for tightening of screws is ±10%.
Drive cage
The drive cage is used to hold removable trays in which the drives, e.g. HDDs and SSDs,
are installed.
The following figure shows the open device with 4 trays, the bottom 3 of which have drives
installed.
● Tray 3: 2 × 2.5" drives, horizontal format
● Tray 2: 2 × 2.5" drives, horizontal format
● Tray 1: 1 × 2.5" drive, vertical format
Additional mounting location: An additional hard disk drive can be installed between the top
mounting location and the enclosure wall.
54
Operating Instructions, 09/2018, A5E45118479-AA
SIMATIC IPC1047