Ricoh FT9105 Operating Instructions Manual page 12

1. Recirculating
document handler
(RDH)
2. Original feed-out unit
cover
3. DF indicator screen
4. Original feed-in unit
cover
5. Document feeder
(DF)
6. One-to-one copy
start key
7. Operation unit
8. Copy tray
9. Upper cover
10. Right front cover
11. Down key
12. Paper tray
13. Front cover
14. Toner replenishing
cover
15. Main switch
16. Original stacker
Originals inserted into the RDH are individually
and automatically fed onto and removed from the
exposure glass.
Open to remove misfed originals.
Ready conditions for automatic feed are indi-
cated. See page 26.
Open to set originals in the recirculating docu-
ment handler.
Originals inserted into the DF are individually and
automatically fed onto and removed from the ex-
posure glass.
Press to make one set of copies when you set
originals in the document feeder.
Operator controls and indicators are located here.
Copies are delivered here.
Open to access the inside of the copier.
Open to access the inside of the copier.
Press to load paper into the paper tray or
change paper. The key stops blinking and stays
lit when the paper tray is ready to be pulled out.
Paper is stored here. The 1st tray can hold up to
500 sheets of plain paper. The 2nd tray and 3rd
tray can hold up to 1,000 sheets of plain paper.
Open to access the inside of the copier.
Open to supply toner.
Switches the copier between on and stand-by
conditions. ("stand-by" means that the anticon-
densation heaters and cooling fans are on.)
Originals are fed out and stacked here when set-
ting originals in the document feeder. If you use
the Preset Copying function, the originals for the
current copy job set in the recirculating document
handler are fed out and stacked here.
See page 27.
See page 27.
See page 31.
COPIER EXTERIOR
3