Commissioning; Overview - Siemens SIMATIC TS Adapter IE Manual

Commissioning

6.1

Overview

Commissioning options
In the factory state and after a parameter reset, the IP parameters of the TS Adapter IE are
set so that remote maintenance and e-mail are not possible.
The following table shows an overview of the various options for commissioning the
TS Adapter IE into operation:
Step
... by direct connection via an
Ethernet connection
1 Set IP parameters by direct
connection:
With TeleService

With the SIMATIC Manager

2 Open configuration interface by
direct connection:
With TeleService

With a browser

3
4
For details on the individual commissioning tasks, refer to the subsections of the same
names in the "Working with the TS Adapter IE (Page 39)" chapter.
TS Adapter IE
Manual, 11/2010, A5E00977705-03
Commissioning ...
... via a remote connection with
TeleService
Establish remote connection:
With TeleService

Open configuration interface via a
remote connection:
With TeleService

Configuration for remote maintenance or e-mailing
Carry out remote maintenance or send e-mail
... via a remote connection without
TeleService
Establish remote connection:
By dial-up

Open configuration interface via a
remote connection:
With a browser

6
37