Ford Thunderbird Manual page 170

03-018-66
REMOVAL AND INSTALLATION (Continued)
-
,
55. Fill crankcase to specified level on oil level
dipstick (6750) with engine oil meeting Ford
specification WSS-M2C 1 53-F.
56. Start engine and check for coolant, oil and fuel
leaks.
Crankshaft
SPECIAL SERVICE TOOL(S) REQUIRED
Crankshaft Damper Remover
Crankshaft Damper Replacer
Slide Hammer
Rear Crankshaft Slinger Remover
Rear Crankshaft Seal Remover
f.
Rear Crankshaft Seal Adapter
Rear Crankshaft Seal Replacer
�
Rear Crankshaft Slinger Replacer
r
Removal
r
r
1 . NOTE: This procedure will remove and install the
r
r
crankshaft (6303) with the engine removed from
�
the vehicle.
r
Remove ignition wires as described in Section
� �
03-Q78.
r
2. Remove six flywheel retaining bolts and remove
flywheel (6375) from crankshaft.
Remove accessory drive belt (8620). Refer to
3.
Section 03-Q5.
4. Remove water pump pulley (8509).
5. Remove drive belt idler pulley (8679) and drive
belt tensioner (68209) with ignition coils ( 1 2029).
6. Remove oil bypass filter (67 1 4) as described.
NOTE: LUBRICATE SEAL
WITH
CLEAN ENGINE OIL
MEETING FORD
SPECIFICAnON
wss-M 2C9 1D-A1 AND
nGHTEN
AFTER SEAL CONTACT
Description
T58P-6316-D
T74P-63 16-B
T50T- 100-A
T95P-670 1 -AH
T95P-670 1 -EH
T95P-670 1 -DH
T95P-670 1 -BH
T95P-670 1 -CH
314 TURN
Engine, 4.6L (2V)
7.
Tool Number
.
Item
8.
AA0630-A
Remove RH and LH valve covers (6582) from
cylinder heads (6049).
LH SIDE SHOWN
RH SIDE SIMILAR
Part
Number Description
1 Valve Cover, RH
6582
2 6584 Valve Cover Gasket
3 N806356-S Stud (LH 4 Req'd, RH 2
Req'd)
Oil Filler Cap
4 6766
5 N8061 83-S Bolt (LH 7 Req'd, RH 9
Req'd)
6 Valve Cover, LH
6582
Cylinder Head, LH
7 6049
8 N807441 Stud Bolt
-
A Tighten to 8� 12
Lb-ln)
Remove crankshaft pulley bolt (6A340) and
crankshaft pulley retaining washer (6378).
1997 Thunderbird, Cougar July 1996
03-o1 B-66
/
FRONT OF
ENGINE
/
AA0636-A
(71-106
Nom