Ford Thunderbird Manual page 146

03·01 8-42
IN-VEHICLE SERVICE (Continued)
2 1 . Install engine front cover on engine.
Retainer Locations
0
REFER TO LEGEND
nGHTEN IN SEQUENCE
Part
Item Number
1 NB08586
2 NB06 177
(Continued)
22. Install stud bolts and bolts retaining engine front
cover to engine. Tighten to 2Q-30 N·m ( 15-22
lb-ft).
23. NOTE: Before installation, inspect intake manifold
for nicks and cuts. Replace intake manifold as
required.
NOTE: Make sure alignment tabs on intake
manifold gaskets are aligned with holes in
cylinder heads.
Position new intake manifold gaskets on cylinder
heads.
Engine, 4.6L (2V)
1
Description
Stud Bolt (3 Req'd)
Bolt (7 Req'd)
Part
Item Number
Description
3 N806300 Stud Bolt (5 Req'd)
60 19 Engine Front Cover
4
24. Position intake manifold on cylinder heads.
25. Install and tighten intake manifold retaining bolts
one through nine in sequence shown in the
following illustration to 2Q-30 N·m ( 1 5-22 1b-ft).
26. Install water thermostat (8575) and new Q-ring,
then position water hose connection and upper
radiator hose and install two bolts. Tighten to
2Q-30 N·m ( 1 5-22 1b-ft).
03·018·42
1997 Thunderbird, Cougar July 1996