Ford Thunderbird Manual page 152

I·
03-01 8-48
IN-VEHICLE SERVICE (Continued)
Installation
NOTE: If a new intake manifold is being installed,
1 .
transfer all necessary components onto new
intake manifold.
Clean sealing surfaces of intake manifold and
cylinder heads.
Position new intake manifold gaskets on cylinder
2.
heads.
Position intake manifold on cylinder heads.
3.
Installation Sequence
Item
1 N808130·S309
2 8592
3 N81 101 1 -S309
(Continued)
Part
Number Description
Bolt (8 Req'd)
Water Hose Connection
Bolt (2 Req'd)
Engine, 4.6L (2V)
NOTE: Make sure alignment tabs on intake
4.
manifold gasket are aligned with holes in cylinder
heads.
Install and tighten intake manifold retaining bolts
one through nine in sequence shown to
( 1 5-22 1b-ft).
Replace D-ring seal on water hose connection.
5.
Position water hose connection and upper
radiator hose and install two bolts and tighten to
N·m
2Q-30
Item Number
4 9424
5 6049
6 6049
(Continued)
( 1 5-22 1b-ft).
�
�
FRONT OF ENGINE
Part
Description
Intake Manifold
Cylinder Head, LH
Cylinder Head, RH
1997 Thunderbird, Cougar July 1996
03-01 8-48
N·m
2Q-30
A24301-A