Daikin Super Multi NX 3MXS-G Series Engineering Data page 443

EDUS121131
Preparation before Operation
 Setting Temperature Indication change
Temperature indication can be changed between Celsius and Fahrenheit before use.
To change from Celsius temperature
indication to Fahrenheit one
1
Press and hold down
same time for 5 seconds while the
Celsius temperature is indicated.
To change from Fahrenheit
temperature indication to Celsius one
2
Press and hold down
same time for 5 seconds while
the Fahrenheit temperature is
indicated.
Notes
 Temperature indication change between Celsius and Fahrenheit on the remote controller
 Change the temperature indication in the modes other than the DRY mode.
In the DRY mode, temperature indication setting cannot be changed because the temperature is not indicated.
 When the Fahrenheit temperature indication is changed to Celsius one, the temperature value
(0.5˚C) will be rounded up. Thus, the preset temperature may be changed.
Example:
A preset temperature of 65˚F (equivalent to 18.5˚C) will be changed to 19˚C (66˚F) b y changing the temperature indication.
In this case, if you change the Celsius temperature indication again to the Fahrenheit one, the preset temperature is shown not as 65˚F but
as 66˚F (equivalent to 19˚C). If the preset temperature is 66˚F (equivalent to 19˚C) and is changed to the Celsius temperature indication,
the indication becomes 19˚C (66˚F). In this case, no change by the temperature indication change is observed.
 When the temperature indication change is set, the preset temperature is transmitted to the
indoor unit so that the reception sound will be heard from the indoor unit.
6
Options
at the
at the
Optional Accessories
1·2
439
4