Operating Your Bath - Kohler K-1913 Homeowner's Manual

Door Switch

Operating Your Bath

Using the Bath
With the door lowered, turn on the water and adjust it to the desired temperature. The water will
run into the footwell and exit through the sidewall drain and toe tap drain (if open) until the door
is closed.
Enter the bath and close the toe tap drain located in the footwell.
Lightly grasp the handle and raise it until the latches on each side of the door engage. The drain
valve will close and the seal will begin inflating.
Fill the bath until the water is just below the overflow drain.
Exiting the Bath
Push the door switch and open the toe tap drain. The water will drain from the bath in
approximately 2 minutes.
When the water level is below the level sensors, the door seals will automatically deflate.
To lower the door, grasp the handle and squeeze while lightly pushing down.
If the bath does not function properly, please refer to the "Troubleshooting Procedures" section.
NOTE: In the event of a power outage, your bath will not function. The door will not lower until power is
restored. Assistance may be required to exit the bath. To avoid this possibility, consider installing an
Uninterruptible Power Supply (UPS) as described in the installation instructions.
1128532-5-E
Toe Tap Drain
Handle
Footwell
4
Sidewall Drain
Kohler Co.