Operating Your Bath - Kohler K-12345M Homeowner's Manual

Operating Your Bath

Fill the Bath
To begin using your bath, close the drain, then fill the bath with water.
Using your hand, test the water temperature for comfort and safety. Carefully enter the bath.
Turn On the Interface
NOTE: User Interface "Sleep" Mode – To enhance your bathing experience, the interface is programmed
to darken after two minutes of inactivity. When in sleep mode, the screen will be blank. To resume normal
operation, touch the interface screen.
NOTE: If the interface is not functioning properly, consult the "Troubleshooting" section of this guide
before calling a qualified service representative.
Touch the screen to turn on the interface. The KOHLER logo will briefly fade in and out, then the
home page will appear.
Navigating the Touch Screen
NOTE: All menu icons displayed on the interface touch screen are enclosed in brackets.
To select a menu option, touch the desired icon.
The brackets of the selected icon will illuminate when the icon is touched, then the screen will
change to the selected menu option.
Home Page
The home page displays the [VibrAcoustic] icon. The left side of the screen displays the [Setting]
icon.
Baths with chromatherapy (shown): Provide options on the right side of the screen for:
[Chromatherapy], [Heated Surface], [Aux], and [Power OFF].
Baths without chromatherapy: Provide options on the right side of the screen for: [Heated Surface],
[Aux] and [Power OFF].
1212240-5-B
Home Page
6
Chromatherapy
(If Equipped)
Heated Surface
Aux
Power OFF
Kohler Co.